![]() ![]() Hopefully, you're using a regulated device. A vent is where your batteries basically give out and, to keep things nice and simple, will start shooting fire out of the bottom of the mod (best case scenario.) In extreme cases, the batteries could potentially explode, taking your mod and perhaps part of your hand with it. To keep things simple and avoid using technical jargon, sub-ohming is mainly for cloud chasers.īut there is one big thing to consider: There is a point where you can go so low on resistance that it overdrives your batteries, causing them to vent. Furthermore, most regulated devices cap voltage at 9.99, so at a lower resistance, you can go higher on the wattage and get a warmer vape, which simply can't be beat with some juices. I've found this site helpful at explaining the benefits of sub-ohming.īasically, the lower your resistance, the thicker your clouds will be. Well that went on way longer than intended. The tank might leak, but the hit you get will definitely be harsh on your throat. If you have the opposite and are using a high PG juice in your tank and put the. This will cause your 1.8ohm coil to likely give you dry (burned) hits, even at very low Wattage. ![]() The only reasons why they wouldn't be interchangeable is if you have a very high VG juice (with very low water %) in your tank. If you hit it like a joint or DTL (Direct to Lung) then either way you are fine, but the. So if you are hitting your Vape like a cigarette, then the 1.8 at 7 Watts is probably the coil for you. 7 coil at the 1.8 level (7W) it is unlikely to produce any vapor. If you try to use the 1.8 at the wattage level you had your. It is just the wattage you run them at is all you need to change. 7 coil MTL with the airflow closed will also cause the coil to be overwhelmed and leak as well.īut the bottom line is this, they ARE plug and play. But it uses more of that juice, more of your battery per hit, and will probably leak if you run higher lvl PG juice in it. It produces much more Vapor, tends to be much warmer and is generally great for desert flavored e liquid. This will have much larger juice openings, is meant to be run anywhere from 15-25 Watts (closer to 15 if using a high percentage VG juice like 80VG/20PG *thick juice) and is the only coil that is really designed to run a high VG juice. In other words the 1.8 ohm coil is meant to be run at lower wattage, will work better with a juice that has a higher level of PG (like 50PG/50VG), and doesn't produce as much vapor, which in turn doesn't use as much juice and also has a lot of people use higher nicotine with these coils (With a weaker coil like this we tend to consider a 12mg juice equal to about 3mg when using a sub ohm coil) This is due to this type of coils inability to vaporize as much liquid (if it had larger holes it would leak) Sometimes they do this with the actual metal wall of the coil and other times it is simply done with a non permeable barrier (the material covering the open holes on the side of the coil). Your 1.8 ohm coil likely has smaller holes in the sides, to reduce the amount of juice (e liquid) flow. The higher the ohm the lower the wattage required to run the coil (especially when it comes to prebuilt coils). But they definitely are made to only handle 10Watts or less. The 1.8, and pretty much any other non sub ohm coil (below 1.0ohm), are normally made for MTL (Mouth to Lung) vaping. ![]()
0 Comments
Leave a Reply. |